Changes

no edit summary
Line 12: Line 12:  
</pre>
 
</pre>
   −
In order to read value use the <b><i>status</i></b> command:
+
In order to read values, use the <b><i>status</i></b> command:
    
  ubus call ioman.gpio.dio0 status
 
  ubus call ioman.gpio.dio0 status
 
  ubus call ioman.relay.relay0 status
 
  ubus call ioman.relay.relay0 status
   −
To change input settings use the <i><b>update</i></b> command and specify a value:
+
To change input settings, use the <i><b>update</i></b> command and specify a value:
    
  ubus call ioman.gpio.dio0 update '{"value":"0"}'
 
  ubus call ioman.gpio.dio0 update '{"value":"0"}'
 
  ubus call ioman.gpio.dio0 update '{"value":"1"}'
 
  ubus call ioman.gpio.dio0 update '{"value":"1"}'
   −
To change relay settings use yhr <i><b>update</i></b> command and specify a state:
+
To change relay settings, use the <i><b>update</i></b> command and specify a state:
    
  ubus call ioman.relay.relay0 update '{"state":"open"}'
 
  ubus call ioman.relay.relay0 update '{"state":"open"}'
Line 43: Line 43:  
  iio (isolated input) input 1021 (to read value refer to gpio1021)
 
  iio (isolated input) input 1021 (to read value refer to gpio1021)
   −
In order to read digital input value use the <b><i>cat</i></b> command:
+
In order to read digital input values, use the <b><i>cat</i></b> command:
    
  cat /sys/class/gpio/gpio14/value
 
  cat /sys/class/gpio/gpio14/value
Line 49: Line 49:  
  cat /sys/class/gpio/gpio1021/value
 
  cat /sys/class/gpio/gpio1021/value
   −
To change an input state usethe <b><i>echo</i></b> command (where "1" is "dry" state and "0" is "wet" state):  
+
To change an input state, use the <b><i>echo</i></b> command (where "1" is "dry" state and "0" is "wet" state):  
    
  echo 0 > /sys/class/gpio/gpio12/value
 
  echo 0 > /sys/class/gpio/gpio12/value
 
  echo 1 > /sys/class/gpio/gpio38/value
 
  echo 1 > /sys/class/gpio/gpio38/value
   −
When one Relay output is open, the other one is closed, so to turn an output on or off, you will have to change value on both pins:
+
When one Relay output is open, the other one is closed; so to turn an output on or off, you will have to change the value on both pins:
    
  echo 1 > /sys/class/gpio/gpio20/value & echo 0 > /sys/class/gpio/gpio22/value
 
  echo 1 > /sys/class/gpio/gpio20/value & echo 0 > /sys/class/gpio/gpio22/value
Line 69: Line 69:  
====One-wire====
 
====One-wire====
 
----
 
----
To read one-wire sensor data you will need to follow these steps:
+
In order to read one-wire sensor data you will need to follow these steps:
    
<ol>
 
<ol>

Navigation menu