RUTX11 LEDs

From Teltonika Networks Wiki
Main Page > RUTX Routers > RUTX11 > RUTX11 Manual > RUTX11 LEDs

This page contains information the different types of LEDs and their behaviour on a RUTX11 device.

Power LED

The power LED is located on the bottom left corner of the front panel, just under the power connector.

Networking rutx11 manual leds power led.png

It indicates whether the device is powered on or not.

State Description
LED turned on Device is powered on.
LED turned off Device is not powered on.

WiFi band LEDs

The WiFi band LEDs are located at the bottom of the front panel of the device, to the left of the Ethernet ports.

Networking rutx11 manual leds wifi leds.png

They display whether a WiFi Access Point (AP) is active on a specific band.

State Description
2.4 LED turned on. At least one 2.4 GHz Access Point is running.
2.4 LED turned off No 2.4 GHz Access Points are running.
5 LED turned on At least one 5 GHz Access Point is running.
5 LED turned off No 5 GHz Access Points are running.

WAN type LEDs

The WAN type LEDs are located at the top-right of the front panel.

Networking rutx11 manual leds wan leds.png

They indicate which type of Internet connection is currently active.

State Description
SIM1 LED on A mobile data connection on SIM1 is active.
SIM1 LED off A mobile data connection on SIM1 is inactive.
SIM2 LED on A mobile data connection on SIM2 is active.
SIM2 LED off A mobile data connection on SIM2 is inactive.
WiFi LED on A WiFi data connection (WiFi WAN) is active.
WiFi LED off A WiFi data connection (WiFi WAN) is inactive.
ETH LED on An Ethernet data connection (wired WAN) is active.
ETH LED off An Ethernet data connection (wired WAN) is inactive.

Mobile network type LEDs

The mobile network type LEDs are located near the SIM card slot.

Networking rutx11 manual leds mobile network type leds.png

They display which type of Internet connection is currently active.

Action Description
3G LED turned on Device is connected to a 3G network.
4G LED turned on Device is connected to a 4G network.
3G blinking Device is connected to a 3G network but hasn't received an IP address.
4G blinking Device is connected to a 4G network but hasn't received an IP address.
3G & 4G LEDs blinking at the same time every 500 ms No SIM card or incorrect PIN.
3G & 4G LEDs turns on and off in a sequence one after the other The device is attempting to connect to a mobile network operator.

Mobile signal strength indication LEDs

The mobile signal strength indication LEDs are located near the SIM card slot.

Networking rutx11 manual leds mobile signal strength leds.png

The number of lit up LEDs represents a different mobile signal strength (RSSI) value in dBm.

No. of lit up LEDS Signal strength
0 ≤ -111 dBm
1 -110 dBm to -97 dBm
2 -96 dBm to -82 dBm
3 -81 dBm -67 dBm
4 -66 dBm to -52 dBm
5 ≥ -51 dBm