Search results

...e on how to use starlink connection and setup failover configuration using RUTX11. These configurations can be implemented on RUT, RUTX and TRB series device [[File:Networking RUTX11 manual starlink wired topology v1.png|border]]

| page = CLI <li>[[RUT230 CLI|RUT230]]</li>

*1 RUTX11 router The figure above depicts a RUTX11 with a Public IP connected by an IPsec tunnel via the Internet to a RUT955.

* One Teltonika Networks router of any type (RUTX11 was used in this example) ==RUTX11 (client) configuration==

*Teltonika-networks router - RUTX11 will be used in this example Once in CLI, execute the following commands in order to install the agent daemon:

* Teltonika Networks router with dual sim card support (RUTX11 is being used in the example); * Prepare RUTX11, power up the device, insert two sim cards, check that both are active and

| name = RUTX11 *** New argument in "gsmctl" CLI command for Carrier aggregation

* Teltonika router or Gateway with Public IP (in this example we use '''RUTX11''') ...ss to the SSH/CLI of the device, we can reach device's CLI via '''System → CLI''' login with '''root''' username and password of your device.

...erfaces_RutOS#SSH|SSH]] or [[Command_Line_Interfaces_RutOS#CLI_.28WebUI.29|CLI]]:<br> root@Teltonika-RUTX11:~# gsmctl -A 'AT+QNWLOCK=?'

* Two Teltonika Networks routers (Two RUTX11 routers will be used in this example) Login to the router's WebUI, navigate to the '''Services → CLI''' page and do the following:

* Teltonika Networks router (RUTX11 will be used in this case). Connect to RUTOS CLI and use command '''ipsec status''', you should see IPsec tunnel via GRE int

This page contains instructions on how to use '''ubus''' commands in [[CLI]] / SSH to scan and pair '''Bluetooth''' devices on '''RUTX10/11'''. *Now login to [[CLI]] or SSH and initialize blesemd, run '''blesemd -D''' command:

* Teltonika Networks router (RUTX11 will be used in this case). Connect to RUTOS CLI and use command '''ipsec status''', you should see IPsec tunnel via GRE int

*A router from the RUTX09 or RUTX11 <li>From router side, connect to it with CLI or SSH client and write in command '''azure_iothub''' and press Enter </li>

<td style="text-align: center;">RUTX09, RUTX11, RUTX12</td> ...using and other serving cell information by executing this command in SSH/CLI: <i>gsmctl -K</i></li>

* One Teltonika Networks router of any type (RUTX11 will be used in this example) ...test an IPsec connection, login to the RUTX WebUI and go to '''Services → CLI'''. Login with user name: '''root''' and the router's admin password. From

* One Teltonika Networks router (RUTX11 will be used in this example) ...est the GRE Tunnel connection, login to RUTX WebUI and go to '''Services → CLI'''. Login with user name: '''root''' and the router's admin password. From

* One Teltonika Networks router of any type (RUTX11 was used in this example) Try to ping the remote VPN endpoint via '''CLI''' or '''SSH''' using this command:

* One Teltonika Networks router of any type (RUTX11 was used in this example) Try to ping the remote VPN endpoint via '''CLI''' or '''SSH''' using this command: